How to troubleshoot a bouncing stacker
This article covers the recommended steps to troubleshoot a stacker that bounces up and down or makes small movements up and down while stacking. ⛔ This article excludes FlexStack models made after serial code DFF19401788. Ⓘ NOTICE Only qualified ...
How to repair belt finger splices
Use the link below for the recommended steps for repairing the finger splice of a primary belt. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, ...
How to adjust the retracting conveyors
Use the link below for the steps to adjusting the speed of the retracting conveyors on a FlexFold. ⛔ This article excludes models without a sorting conveyor. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this ...
How to troubleshoot a “primary fold too long detected” or “sensor crossfold too long detected" error message
This article covers the recommended steps to troubleshooting for the error message “primary fold too long detected” or “sensor crossfold too long detected.” ? Tools you may need: ☐ Set of metric Allen wrenches Ⓘ NOTICE Only qualified personnel ...
How to test the solenoid valve for the lifting stacker
The following article describes how to test the solenoid valve located on the lifting stacker. If you are able to follow the test in its entirety and air is only coming out of the hose when the dial is positioned as specified below, then the solenoid ...