This article lists the steps on how to remove and replace the 3rd Crossfold Drivebelt (# 10003.0) from a 3 crossfold AT230 folder. This belt is located within the crossfold section of the machine. The image below is viewed from laying down underneath ...
This article covers the recommended steps to troubleshooting for the error message “primary fold too long detected” or “sensor crossfold too long detected.” ? Tools you may need: ☐ Set of metric Allen wrenches Ⓘ NOTICE Only qualified personnel ...
Use the link below for the steps to adjusting the primary fold belt on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...
Use the link below for the recommended steps for repairing the finger splice of a primary belt. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, ...
This article explains how to use string mode on a new or existing program for FlexFold models that are AT, AG, or Slim. ⛔ This article only applies to machines with string mode previously loaded on the equipment. Ⓘ NOTICE Only qualified personnel ...