Use the link below for a demonstration of how to adjust the speed of the stacker doors using the airflow valves. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should ...
Use the link below for the steps to adjusting the speed of the retracting conveyors on a FlexFold. ⛔ This article excludes models without a sorting conveyor. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this ...
FlexFold Drywork stacker doors use flange bearings (part #10378.0) made of a hardened steel core encased in a sacrificial aluminum housing. This design is meant to protect more expensive components if doors misalign. Stronger Isn't Better A stronger ...
This article lists the steps on how to remove and replace the 3rd Crossfold Drivebelt (# 10003.0) from a 3 crossfold AT230 folder. This belt is located within the crossfold section of the machine. The image below is viewed from laying down underneath ...
Use the link below for the steps to adjusting the primary fold belt on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...