How to adjust the sensor sensitivity and light/dark operate mode on 10098.1
Use the link below for the recommended steps to adjusting the sensor to maximum sensitivity.
Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or service this machine. Read and understand the manual in its entirety before proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life. By proceeding, you are indicating that you acknowledge and agree that Foltex USA is not responsible for any damage to property or persons while accessing and/or using this service.
🔧 Tools you may need: 𐄂 #2 flat screwdriver
Click this link for a step by step instructional video.
Related Articles
How to adjust drive belt tension
Use the link below to follow the recommended steps to adjusting the tension of a drive belt. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, ...
How to replace a drive roller
The link below shows the recommended steps to replacing a drive roller. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or service this ...
How to calibrate the HMI touchscreen
If the area touched on the HMI screen does not correspond to the area selected then the touchscreen is in need of calibration. Follow the instructions below to correctly calibrate the HMI. Ⓘ NOTICE Only qualified personnel familiar with the ...