How to install Teflon tape on skis
Use the link below for the recommended steps to installing Teflon tape to the bottom of skis.
Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or service this machine. Read and understand the manual in its entirety before proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life. By proceeding, you are indicating that you acknowledge and agree that Foltex USA is not responsible for any damage to property or persons while accessing and/or using this service.
🔧 Tools you may need: 𐄂 6mm hex key 𐄂 abrasive pad 𐄂 degreaser 𐄂 utility knife
Click this link for a step by step instructional video.
Related Articles
How to clean skis
Use the link below for a short video detailing how to clean the skis on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...
How to adjust the retracting conveyors
Use the link below for the steps to adjusting the speed of the retracting conveyors on a FlexFold. ⛔ This article excludes models without a sorting conveyor. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this ...
How to adjust a primary fold belt
Use the link below for the steps to adjusting the primary fold belt on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...
What is string mode?
This article explains how to use string mode on a new or existing program for FlexFold models that are AT, AG, or Slim. ⛔ This article only applies to machines with string mode previously loaded on the equipment. Ⓘ NOTICE Only qualified personnel ...
Information on FlexFold Drywork Stacker Door Bearings (10378.0)
FlexFold Drywork stacker doors use flange bearings (part #10378.0) made of a hardened steel core encased in a sacrificial aluminum housing. This design is meant to protect more expensive components if doors misalign. Stronger Isn't Better A stronger ...