How to repair belt finger splices

• Related Articles

• How to adjust a primary fold belt

  Use the link below for the steps to adjusting the primary fold belt on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...

• How to troubleshoot a “primary fold too long detected” or “sensor crossfold too long detected" error message

  This article covers the recommended steps to troubleshooting for the error message “primary fold too long detected” or “sensor crossfold too long detected.”  ? Tools you may need:  ☐ Set of metric Allen wrenches  Ⓘ NOTICE  Only qualified personnel ...

• How to troubleshoot when no airblasts are occurring on the primary deck and no error message is displayed

  This article covers the recommended steps for troubleshooting if primary blasts are not occurring when an item enters the primary deck.  ⛔ This article excludes models without a gap detection sensor (also called turbo feature or turbo option).     Ⓘ ...

• What is string mode?

  This article explains how to use string mode on a new or existing program for FlexFold models that are AT, AG, or Slim. ⛔ This article only applies to machines with string mode previously loaded on the equipment.   Ⓘ NOTICE  Only qualified personnel ...

• Information on FlexFold Drywork Stacker Door Bearings (10378.0)

  FlexFold Drywork stacker doors use flange bearings (part #10378.0) made of a hardened steel core encased in a sacrificial aluminum housing. This design is meant to protect more expensive components if doors misalign. Stronger Isn't Better A stronger ...