How to replace a drive roller
The link below shows the recommended steps to replacing a drive roller.
Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or service this machine. Read and understand the manual in its entirety before proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life. By proceeding, you are indicating that you acknowledge and agree that Foltex USA is not responsible for any damage to property or persons while accessing and/or using this service.
🔧 Tools you may need: 𐄂 8mm hex key 𐄂 pry bar
Click this link for a step by step instructional video.
🗉 The video above features a FlexFold, but the same steps apply to all machines.
Related Articles
How to adjust drive belt tension
Use the link below to follow the recommended steps to adjusting the tension of a drive belt. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, ...
How to adjust the sensor sensitivity and light/dark operate mode on 10098.1
Use the link below for the recommended steps to adjusting the sensor to maximum sensitivity. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, ...
How to Install a new HMI Touchscreen
Removal and replacement of the screen itself is pretty straightforward. There are three objectives involved in this procedure: Update HMI display time and date Enable the USB port so the HMI display will recognize the port when downloading software ...