This article covers the recommended steps for troubleshooting if primary blasts are not occurring when an item enters the primary deck. ⛔ This article excludes models without a gap detection sensor (also called turbo feature or turbo option). Ⓘ ...
Use the link below for the steps to adjusting the primary fold belt on a FlexFold. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, and/or ...
This article covers the recommended steps to troubleshooting for the error message “primary fold too long detected” or “sensor crossfold too long detected.” ? Tools you may need: ☐ Set of metric Allen wrenches Ⓘ NOTICE Only qualified personnel ...
Use the link below for the recommended steps for repairing the finger splice of a primary belt. Ⓘ NOTICE Only qualified personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, ...
This article lists the steps on how to remove and replace the 3rd Crossfold Drivebelt (# 10003.0) from a 3 crossfold AT230 folder. This belt is located within the crossfold section of the machine. The image below is viewed from laying down underneath ...